赛车pk10技巧经验

Lubrication method of epilation machine

hit count: Updated: 2019-01-21 07:58:01 share it:
    Do you know the lubrication methods of the epilator? The following editor will introduce the lubrication method of hair removal machine.
    1. When the ice in the freezer of the epilator reaches the required thickness, the hot air discharged from the compressor is re-introduced into the wall of the ice maker to replace the low-temperature liquid refrigerant. A thin film of water is formed between the ice in the freezing equipment and the wall of the evaporation tube. When the ice falls freely into the groove below by gravity, it acts as a lubricant.
    2. Make up the water valve through the water pipe of the depilation machine, and the water automatically enters a water storage tank, and then the water is pumped through the flow control valve to the diverter, where the water is evenly sprayed onto the surface of the depilation machine, like a water curtain. The same way it flows through the wall of the ice maker, the water is cooled to the freezing point, and the water that has not been frozen by evaporation will flow into the water storage tank through the porous tank and restart the cycle work.
    3. The water produced during the ice mining cycle will be returned to the water storage tank through the porous tank, which also prevents wet ice from being discharged by the machine. Air-cooled, water-cooled or evaporative condensers are available. The evaporative type is installed higher than the ice maker in the depilator's refrigeration equipment, the water-cooled condenser is installed under the ice maker or the refrigeration system, and the air-cooled condenser is installed in The ice maker can be installed together or outdoors. The epilator can be used on a boat or on the coast, using seawater for cooling.
    I hope the above content introduced by the editor is helpful to everyone. If you have any other questions, please call our telephone for consultation. We will serve you wholeheartedly.